Last Modified: 11-29-2007 1.6 A
Service Category: Vehicle Exterior Section: Window/Glass
Model Year: 2008 Model: Sequoia Doc ID: RM000003GT7000X
Title: WINDOW / GLASS: BACK DOOR POWER WINDOW MOTOR: REMOVAL (2008 Sequoia)

REMOVAL

1. REMOVE BACK DOOR CENTER GARNISH DOOR / HATCH: BACK DOOR: DISASSEMBLY (2008 Sequoia)+

2. REMOVE BACK DOOR SIDE GARNISH RH DOOR / HATCH: BACK DOOR: DISASSEMBLY (2008 Sequoia)+

3. REMOVE BACK DOOR SIDE GARNISH LH DOOR / HATCH: BACK DOOR: DISASSEMBLY (2008 Sequoia)+

4. REMOVE BACK DOOR STRAP COVER DOOR / HATCH: BACK DOOR: DISASSEMBLY (2008 Sequoia)+

5. REMOVE BACK DOOR PULL STRAP DOOR / HATCH: BACK DOOR: DISASSEMBLY (2008 Sequoia)+

6. REMOVE BACK DOOR TRIM BOARD ASSEMBLY DOOR / HATCH: BACK DOOR: DISASSEMBLY (2008 Sequoia)+

7. REMOVE BACK DOOR SERVICE HOLE COVER DOOR / HATCH: BACK DOOR: DISASSEMBLY (2008 Sequoia)+

8. REMOVE MULTIPLEX NETWORK BODY ECU (w/ Power Back Door) DOOR / HATCH: BACK DOOR: DISASSEMBLY (2008 Sequoia)+

9. REMOVE NO. 2 BACK DOOR SERVICE HOLE COVER DOOR / HATCH: BACK DOOR: DISASSEMBLY (2008 Sequoia)+

10. REMOVE REAR WIPER ARM HEAD CAP WIPER / WASHER: REAR WIPER MOTOR: REMOVAL (2008 Sequoia)+

11. REMOVE REAR WIPER BLADE ASSEMBLY WIPER / WASHER: REAR WIPER MOTOR: REMOVAL (2008 Sequoia)+

12. REMOVE REAR WIPER MOTOR ASSEMBLY WIPER / WASHER: REAR WIPER MOTOR: REMOVAL (2008 Sequoia)+

13. REMOVE REAR WIPER MOTOR GROMMET WIPER / WASHER: REAR WIPER MOTOR: REMOVAL (2008 Sequoia)+

14. REMOVE LINEAR WIPER STEP RH DOOR / HATCH: BACK DOOR: DISASSEMBLY (2008 Sequoia)+

15. REMOVE BACK DOOR OUTSIDE MOULDING LH

(a) Disengage the 5 clips and remove the back door outside moulding.

16. REMOVE BACK DOOR OUTSIDE MOULDING RH

HINT:

Use the same procedure as for the LH side.

17. REMOVE BACK DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY EXTERIOR PANELS / TRIM: BACK DOOR BELT MOULDING: REMOVAL (2008 Sequoia)+

18. REMOVE BACK DOOR GLASS RUN DOOR / HATCH: BACK DOOR: DISASSEMBLY (2008 Sequoia)+

19. REMOVE BACK DOOR GLASS DOOR / HATCH: BACK DOOR: DISASSEMBLY (2008 Sequoia)+

20. REMOVE BACK DOOR POWER WINDOW REGULATOR ASSEMBLY DOOR / HATCH: BACK DOOR: DISASSEMBLY (2008 Sequoia)+

21. REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY RH

(a) Remove the 3 nuts and power window regulator motor.

(b) Remove the 2 screws and power window regulator base plate.

(c) Using needle nose pliers, remove the drum and wire guide from the motor.

NOTICE:

Do not use a screwdriver, etc. when removing them.